old stuff - whoson and zmailer

[Tomaz Borstnar <tomaz.borstnar@over.net>]

Hello!

	using latest s18 and whoson 1.05 I can't make them work together. I use 
wtest to add entry to whosond and check to see if it is there. So far so 
good, but then I try to connect from that remote IP host and try to send 
mail from that remote IP it fails like it is suppose to fail for remote 
relaying, but then then it appears that my whoson config is not OK. wtest 
looks OK:

game% ./wtest login tomaz 10.0.0.1
rc=0, info="LOGIN OK"
again? n
game% ./wtest query tomaz
rc=0, info="10.0.0.1"
again? n

So it must be misconfiguration at zmailer part:

#| -- 2nd alternate: No MX target usage, DNS existence verify
#|    Like the 1st alternate, except will verify the sender (mail from:<..>)
#|    address for existence of the DNS MX and/or A/AAAA data -- e.g. validity.
#
.                       relaycustomer - relaytarget - senderokwithdns + 
test-dns-rbl + trust-whoson +
[0.0.0.0]/0             relaycustomer - relaytarget - senderokwithdns + 
test-dns-rbl + trust-whoson +

I compiled zmailer properly, because I can see smtpserver complain about 
connection refused if whosond is not running.

smtpserver+whoson combination is not dependent on mail address, right?

Thanks in advance.

Tomaz

----
Tomaz Borstnar <tomaz.borstnar@over.net>
"Love is the answer to the final question you ask" - Unknown